Datalogic Scanning 9500 ユーザーズマニュアル

EAN-13 Enable

This feature specifies an EAN 13 label ID to be added to bar code data.

To set this feature:

To set this feature:

1. Scan the SWITCH bar code.

2. Scan the bar code, 

 below. You’ll need to 

cover any unused bar codes on this and the facing page to ensure the 
scanner reads only the bar code you intend to scan.

3. Scan the appropriate digits from the keypad in Appendix C that rep-

resent the desired Label ID characters; entered as two hex pairs. A 
table containing the 

 and their corresponding 

Hex Values is available in the inside back cover of this manual. 
ASCII parameters must be input by scanning a pair of hexadecimal 
digits for each character. Thus, to set a two-character value of AB, 
bar codes containing the digits ‘4’, ‘1’, ‘4’, and ‘2’ must be scanned. 
The selectable range for this option is any hex value from 00 to FF.

4. Complete the programming sequence by scanning the SWITCH 

bar code.

SET EAN 13 LABEL ID

RS-232 Label ID Control, designates whether the