Datalogic Scanning 8500 ユーザーズマニュアル

 8500 Scanner

This feature specifies a UPC-A 5-Digit Supplemental label ID to be added 
to bar code data.

To set this feature:

1. Scan the SWITCH bar code.

2. Scan the bar code, SET UPC-A 5-DIGIT SUPPLEMENTAL 

LABEL ID below. You’ll need to cover any unused bar codes on 
this and the facing page to ensure the scanner reads only the bar 
code you intend to scan.

3. Scan the appropriate digits from the keypad in Appendix C that 

represent the desired Label ID characters; entered as two hex 
pairs. A table containing the ASCII Character Set and their corre-
sponding Hex Values is available in the inside back cover of this 
manual. ASCII parameters must be input by scanning a pair of 
hexadecimal digits for each character. Thus, to set a two-character 
value of AB, bar codes containing the digits ‘4’, ‘1’, ‘4’, and ‘2’ 
must be scanned. The selectable range for this option is any hex 
value from 00 to FF.

4. Complete the programming sequence by scanning the SWITCH 

bar code.

SET UPC-A 5-DIGIT SUPPLEMENTAL LABEL ID

The programming feature, RS-232 Label ID Control, designates
whether the Label ID is transmitted as a prefix or suffix or if Label ID is dis-
abled.