Canon M11037 ユーザーズマニュアル
20
Installing the Scanner
IMPORTANT
● Make sure that the scanner and your PC are both turned off when
connecting the scanner to the PC.
● The factory default setting for the terminator of the scanner is set to ON as
default. Be sure to turn off all terminators of the SCSI devices connected
between the scanner and the PC.
between the scanner and the PC.
Note
The factory default setting for the SCSI ID is “2”.
You can set the SCSI ID by using the DIP-switch provided on the rear side of
the scanner. In the DIP-switch settings, the SCSI ID can be set to ON by
turning the switch to the upper position, or OFF by turning it to the lower
position.
the scanner. In the DIP-switch settings, the SCSI ID can be set to ON by
turning the switch to the upper position, or OFF by turning it to the lower
position.
1
ON
2
DIP Switch
Default Settings
(SCSI ID = 2)
Refer to the following table when setting the SCSI ID. If there are other SCSI
devices connected to or inside the PC, make sure to set a unique ID for the
scanner.
devices connected to or inside the PC, make sure to set a unique ID for the
scanner.
SCSI ID
SW1
SW2
2
OFF
OFF
3
OFF
ON
4
ON
OFF
5
ON
ON