Toro 1200 ユーザーズマニュアル

Component Testing

For accurate resistance and/or continuity checks, elec-

trically disconnect the component being tested from the 

circuit (e.g. unplug the ignition switch connector before 

doing a continuity check). 

The on/off switch is used to shut the engine off. When 

the on/off switch is in the off position, the engine arma-

ture is grounded to prevent the engine from running. 

This switch is located handle panel (Fig. 3). 

In the OFF position, there should be continuity between 

the two switch terminals. In the RUN position, there 

should not be continuity between the two switch termi-

nals. 

Figure 3 

Figure 4 

Line Painter 1200 

Electrical System