Toro 1200 ユーザーズマニュアル

Line Painter 1200

Figure 22

FRONT

RIGHT

2

3

4

1

5

6

7

8

1. Drain paint tank (see Operator’s Manual). Operate

line painter in the flush mode to clean paint tubes.

2. Park machine on a level surface, stop engine, en-

gage parking brake and remove key from the ignition

switch. Remove high tension lead from the spark plug

and position the lead away from the spark plug.

3. Remove flush tank (see Flush Tank Removal in this

section).

4. If equipped, remove pressure gauge from machine.

5. Label hoses connected to pressure regulator to as-

sist in assembly. Remove hoses from fittings on pres-

sure regulator (Fig. 23) (see Quick Disconnect Fitting in

the General Information section).

6. Remove pressure regulator from machine using Fig-

ure 22 as a guide.

7. If necessary, remove fittings from pressure regulator.