Opticon LPN 1736 ユーザーズマニュアル

 

 
Opticon scanners are preprogrammed at the factory with default settings representing the 
settings most commonly used by our customers.  In most applications, the scanner will 
work right out of the box without the need for additional programming. 
 
If desired, you can change or program the settings of the scanner by reading special 
programming bar code symbols.  These special bar codes are contained in this manual. 
 
In order to read these special programming bar codes, the scanner must first enter the 
“programming mode”.    This is accomplished by scanning the following bar code 
symbol: 
 
 
 
 

 [[ 

Start/Stop Programming Mode 

 
 
 
 
Scanning this programming bar code puts the scanner into the programming mode.  The 
scanner will beep continuously indicating that it is in programming mode.  In this mode 
the scanner will only read special programming bar codes.  It will not read regular bar 
codes.   
 

Page 142