Opticon CRD972X ユーザーズマニュアル

Get USB driver
• Download the USB driver from the software 

download section on the Opticon website.
(The USB driver can be found as software for 
either CRD972X or OPL972X)

• Place the file on your hard disk in a separate 

directory and unpack the contents of the file.

Choose proper place
Place the cradle in normal office conditions, avoid a 
place under strong light.

Connect interface cable
Connect the cable between the cradle and the host 
computer.

Connect power
Connect the power supply. 

Add New Hardware
If the wizard for new hardware is not started 
automatically, go to ‘Control Panel’ – ‘Add 
Hardware’.
• Select the option to search for the best driver for 

your device. Browse for the directory where you 
put the contents of the downloaded USB driver 
file.

• Windows should recognize the USB cradle as 

‘USB High Speed Serial Converter’

• Possibly (depending on Windows version) the 

system will ask for the ‘ftdiport.cat’ file. This can 
be skipped (‘Skip File’ button).

• Finish the installing procedure. A message will 

pop-up that new hardware is found, recognized 
as USB Serial Port.

• Possibly (depending on Windows version) the 

system asks to insert a disk labeled ‘FTDI USB 
Drivers Disk’, click on OK and in the next screen 
skip this action.

• When the USB driver is installed, you can check 

on ‘Control Panel’ – (‘System’) – ‘System 
Properties’ (‘Hardware’) – ‘Device Manager’-
menu if the ‘USB High Speed Serial Converter’ is 
recognized.

• Check at properties for the COMport: ‘USB Serial 

Port (COMn). This information might be needed 
for application loading. 

Cradle installed
Place the bar code data collector in the cradle

LED indicator
Typical LED indications are:
red: power is on
flashing green: collector sends to host
flashing yellow: host sends to collector