Sharp MX-FX13 ユーザーズマニュアル

When another fax machine sends a fax to your machine, your machine will ring*, automatically receive the fax, and 
begin printing. (This is called automatic reception.)
If you do not wish to have received faxes printed immediately, use the print hold function to hold received faxes in 
memory for printing at your convenience (all received faxes will be printed at once). To enable this function and print 
received faxes, see "FAX PRINT HOLD FUNCTION" on page 29.

The LINE indicator lights up.

• When reception ends, the 

machine sounds a beep.

• When the optional job 

separator tray kit is installed, 
received faxes are output to 
the job separator.

If a fax cannot be printed because the machine is out of the appropriate paper and another fax is subsequently 
received that can be printed, the subsequently received fax will be printed before the fax that cannot be printed.
This also happens when there are several faxes in memory that cannot be printed.
This function can be disabled in the system settings. (See "EARLIER OUTPUT" on page 110.)

• You can store a transmission job while fax reception is in progress. (See "Storing transmission jobs (memory 

• To print received fax pages on both sides of the paper, enable "DUPLEX RECEPTION" (page 109) in the 

system settings.

• If a extension phone is not connected to the machine, use automatic reception.
• In order to receive faxes, paper must be loaded in the paper tray. See "LOADING PAPER" in the Operation 

Guide for the machine to load appropriate paper. Incoming faxes will be automatically adjusted to the 
orientation of the printing paper, so there is no need to load both horizontally (

) and vertically (

) oriented 

paper. However, when a fax smaller than A4 (8-1/2" x 11") is received, the size of paper used to print the fax 
will differ depending on the orientation (horizontal or vertical) of the original in the sending machine.

The machine has been set to ring twice before 
beginning automatic reception. You can change the 
number of rings to any number from 0 to 9 in the 
system settings. (See "#OF RINGS AT. RX" on 
page 108.)
If the number of rings is set to 0, the machine will 
receive faxes without ringing.

The job separator has a sensor that detects 
when a tray is full. When approximately 100 
sheets accumulate in a tray, a message 
appears in the display and fax printing stops. 
If this happens, remove the sheets. Printing 
will resume momentarily.