Radio Shack 20-107 ユーザーズマニュアル

After you have programmed FIPS codes for one or more SAME 
locations, you can activate SAME Standby Mode:

1.  Press 

, then press 



 or 

 to select the strongest NOAA 

channel for your area.

2.  Press SKIP to select Standby Mode. The speaker silences and 

SKIP

 = 

Normal

 appears at the bottom of the screen. 

iSCAN monitors the selected weather channel for SAME alerts 
that match the locations you have programmed. If a matching 
alert is detected, iSCAN will sound an alarm, display the type of 
alert on the screen, and monitor the alert message.

 Note: Press SKIP again to return to Normal Weather Mode.

Many areas of the country have amateur radio repeaters that have 

been designated as “Skywarn” repeaters. During times of severe 

weather, these repeaters are used to relay reports of severe weather 

directly to meteorologists at a local National Weather Service 

forecast office. By monitoring Skywarn repeaters, you’ll hear about 

severe weather conditions before they are reported by local radio 

and television media. 
To monitor Skywarn, store your local Skywarn repeater frequencies as 
objects in the Skywarn playlist:

1.  Browse for Skywarn frequencies in the iSCAN Library and import 

them to the Skywarn playlist. (See “Programming iSCAN” on page 20.)

2.  Enable the Skywarn playlist. (See “Enabling Playlists” on page 26.)
3.  Quickly access the Skywarn playlist by pressing 

 while iSCAN 

is in Normal Weather Mode.

Your iSCAN comes with a 2 GB SD card already formatted, installed,
and ready for use. To manage SD card contents, remove it from iSCAN 
and insert it into your computer’s SD card slot or external SD card 
reader. External SD card readers are available at your local RadioShack 
store or RadioShack.com.
You can then use the iSCAN PC Application to:

•  Access the card
•  Update the Library
•  Edit iSCAN’s configuration and stored objects
•  Backup data stored on the card
•  Optimize the card
•  Reformat the card if necessary