IBM 5.5 ユーザーズマニュアル

Add the PtnEntityID and PtnNative1 columns to the alerts.status table using the 
following steps. The column names are case-sensitive:

1.

Check that the ObjectServer is running.

2.

Execute the following command to start nco_sql. This command will change the 
object server name as appropriate for your system. Enter the root password when 
prompted.

$OMNIHOME/bin/nco_sql -username root -server NCOMS

3.

Enter the commands below exactly as shown. The caret character is the nco_sql 
prompt and must not be entered.

> alter table alerts.status add column PtnEntityID varchar(255);

> go

> alter table alerts.status add column PtnNative1 varchar(255);

> go

> alter table alerts.status add column NmosDomainName varchar(255);

> go

> exit

If you did not use the default name when you installed the Netcool/OMNIbus 
ObjectServer, you need to follow the steps below before you can run visualization:

1.

If you copied the tl1.rules and tl1.props files to the 
$OMNIHOME/tsm/solaris2

 directory, change to that directory. 

If you plan to use the -rulesfile and -propsfile command line arguments to 
use the files in the <netcool_install_dir>/etc/precisiontn directory, 
change to that directory.

2.

Open the tl1.props file with a text editor. 

3.

Find the following line (toward the bottom of the file): 

#Server: "NCOMS"

4.

Uncomment the line by removing the # character. 

5.

Replace NCOMS with the name of your ObjectServer. 

6.

Save and close the file.

As an alternative, you can give the name of your ObjectServer to Netcool/Precision TN 
using a command line argument each time you start Netcool/Precision TN. To do this, 
change directory to <netcool_install_dir>/precisiontn/bin and enter:

./precisiontn -server ObjectServername

where ObjectServername is replaced by the name of your ObjectServer.