Lucent Technologies 555-232-102 ユーザーズマニュアル

DWBS Installation Checklist

Issue 5   June 1999

The following table is a checklist of tasks for completing a DWBS installation. 
Where appropriate, references to the corresponding pages for a description of the 
tasks indicated are also provided. Unless otherwise indicated, the page 
references are for the DWBS Installation document.

Wired the CAUs according to the SDSC installation 
plan?

3-30 

Oriented the CAUs (azimuth and tilt) according to the 
SDSC installation plan using brackets when required? 

3-49 

Wired the WFBs according to the SDSC installation 
plan?

3-20 

Installed and wired the power supplies for each WFB 
that has an attached CAU?

3-21 

Verified that the DC power leads for WFB are 
“doubled up?” 

3-13

Placed the TN789 circuit packs into the appropriate 
slots?

3-11 

Terminated WFBs 1A and 1B to ports 1 and 2 of the 
first TN789 circuit pack? 

3-10 

Terminated WFBs 2A and 2B to ports 1 and 2 of the 
second TN789 circuit pack?

3-10 

Terminated all remaining WFBs properly?

3-10

Installed the WT download cable?

4-7 

Upgraded the switch software to V5 or greater?

2-1 

Enabled wireless capabilities via the Optional 
Features form by entering the change 
system-parameters customer-options command? 
(Remember to log off and log on again.) 

2-2 

Enabled wireless capabilities via the 
Wireless-Related System-Parameters form by 
entering the change system-parameters wireless 
command? 

2-3 

Administered the Carrier-Frequencies form?

2-7