Multiquip b46s90 ユーザーズマニュアル

7.  Adjustment of the throttle cable tension may be 

required. If so, loosen the 

adjusting nut (top nut) on 

the throttle cable receiver (Figure 7) and loosen or 

tighten the 

locking nut (bottom nut). Retighten 

adjusting nut.

1.  Connect the black tail wire from the engine to the black 

safety stop wire from the centrifugal stop switch as 

shown in Figure 8.

1.  For 

Standard Handle models expose the pitch cable 

to maximum by turning the blade pitch star wheel 

(Figure 9) fully counterclockwise for no pitch (blades 

flat).

ADJUSTING

NUT (TOP)

LOCKING NUT

(BOTTOM)

If the throttle lever does not return to the "neutral" 

position with throttle backed off, loosen adjuster nut 1/2 

turn at a time, tighten and recheck. Readjust throttle 

tension as necessary.

SAFETY STOP WIRE

CONNECTION POINT

INCREASE

BLADE PITCH

(CW)

DECREASE

BLADE PITCH

(CCW)

2.  For 

Quick Pitch™ Handle models expose the pitch 

cable to maximum by grasping the T-handle (Figure 10), 

then squeezing the trigger lock and pushing the 

T-handle forward for no pitch (blades flat).

3.  Remove brass set nut #1 from the blade pitch cable 

end as shown in (Figure 11).

4.  Thread brass set nut #2 (Figure 11) towards the cable 

as far as possible.

5.  Insert the cable end through the yoke eyelet 

(Figure 12). Tighten brass set nut #1 by hand to remove 

all the slack from the cable.

T-HANDLE

TRIGGER

(SQUEEZE)

NO PITCH

FORWARD

BLADE

PITCH

CABLE

BRASS SET

NUT #1

BRASS SET

NUT #2