Multiquip b46s90 ユーザーズマニュアル

Machine has a perceptible rolling motion 

while running.

Main shaft?

The main output shaft of the gearbox 

assembly should be checked for straightness. 

The main shaft must run straight and cannot 

be more than 0.003"" (0.08 mm) out of round 

at the spider attachment point.

Yoke?

Check to make sure that both fi ngers of the 

yoke press evenly on the wear cap. Replace 

yoke as necessary.

Blade Pitch?

Check to ensure that each blade is adjusted 

to have the same pitch as all other blades. 

Adjust per maintenance section in manual.

Clutch slipping or sluggish response to 

engine speed change.

Worn V-belts?

Replace V-belt.

Hand clutch out of adjustment?

Adjust per instructions in maintenance 

section of this manual.

Worn or defective hand clutch parts?

Replace parts as necessary.

Worn bearings in gearbox?

Rotate input shaft by hand. If shaft rotates 

with diffi culty, check the input and output 

shaft bearings. Replace as necessary.

Worn or broken gears in gearbox?

Verify that the gearbox shaft rotates when 

the input shaft is rotated. Replace both the 

worm and worm gear as a set.

Trowel blades do not rotate.

Defective clutch?

Replace clutch.

Broken V-belt?

Replace V-belt.

Defective ON/OFF switch?

Check and replace ON/OFF switch if 

necessary.

Defective centrifugal ON/OFF switch?

Check and replace centrifugal ON/OFF 

switch if necessary.