Sharp R-1505 ユーザーズマニュアル

29

1. Disconnect the power supply cord.
2. Open the door and block it open.
3. To discharge the high voltage capacitor, wait for 60

seconds.

4. Remove the one (1) screw holding the base cover to the

oven cavity back plate.

5. Remove the three (3) screws holding the base cover to

the oven cavity front face plate.

6. Open the base cover.
7.   Release the two hood lamp sockets from the base cover.
8. Remove the base cover from the oven cavity by pulling

down and moving to the left slightly.

10. Pull the wire leads from the oven lamp socket by pushing

the terminal hole of the oven lamp socket with the small
flat type screw driver.

11. Now, the oven lamp socket is free.

TURNTABLE MOTOR
9. Disconnect the wire leads from the  turntable motor.
10.Remove one (1) screw holding turntable motor to the

oven cavity.

11.Now the turntable motor is free.

HOOD LAMP SOCKET
9. Screw the hood lamp off from the lamp socket.
10.Disconnect the wire leads from the lamp socket by

pushing the terminal hole of the lamp socket with the
small flat type screw driver.

11. Now, the lamp socket is free.

1. Disconnect the power supply cord.
2. Open the door and block it open.
3. Remove three (3) screws holding the hood exhaust

louver to oven cavity front face plate.

4.    Remove the hood exhaust louver from the oven by

pushing the right and left tabs of the hood exhaust louver.
(Refer to procedure of "HOOD EXHAUST LOUVER
REMOVAL")

7. Turn the lamp socket and release it from the magnetron

duct.

8. Screw the oven lamp off from the lamp socket.
9.  Now, the oven lamp is free.

1. Disconnect the power supply cord and remove the oven

from wall and remove outer case. (Refer to procedure of
"Removal of Oven from Wall" and "Outer case Removal")

2. Open the door and block it open.
3. To discharge the high voltage capacitor, wait for 60

seconds.

4. Push the lever of positive lock

®

 connector.

5. Pull down on the positive lock

®

 connector.

CAUTION: WHEN CONNECTING THE POSITIVE LOCK

®

CONNECTORS TO THE TERMINALS, IN-
STALL THE POSITIVE LOCK

®

 SO THAT THE

LEVER FACES YOU.

5. Remove one (1) screw holding the control panel to the

oven cavity front face plate.

6. Release the control panel from the oven cavity front face

plate by lifting it up and tilting top edge back.

Oven lamp
socket

Terminal

Wire lead

Terminal hole

Flat type small
screw driver

1. Disconnect the power supply cord.
2. Open the door and block it open.
3. To discharge the high voltage capacitor, wait for 60

seconds.

4. Remove three (3) screws holding the hood exhaust

louver to oven cavity front face plate.

5. Remove the hood exhaust louver from the oven by

pushing the right and left tabs of the hood exhaust louver.
(Refer to procedure of "HOOD EXHAUST LOUVER
REMOVAL")

6. Remove one (1) screw holding the control panel to the

oven cavity front  face plate.

7. Release the control panel from the oven cavity front face

plate by lifting it up.

8. Disconnect the wire leads from the relays RY1 and RY2.
9. Disconnect the connectors CN-A, CN-B and CN-E from

the control unit.

10. Remove the control panel assembly from the oven.
11.Now, the control panel assembly is free.
12.Disconnect the connector CN-G from the control unit.

Terminal

Push

Pull down

1

2

Lever

Positive lock®

connector