Sharp R-1501 ユーザーズマニュアル

32

1. Disconnect the power supply cord.
2. Open the door and block it open.
3. To discharge the high voltage capacitor, wait for 60

seconds.

4. Remove the three (3) screws holding the hood exhaust

louver to the oven cavity front face plate.

5. Remove the hood exhaust louver from the oven cavity by

pushing the right and left tabs of the hood exhaust louver.
(Refer to the procedure of "HOOD EXHAUST LOUVER
REMOVAL".)

6. Remove door assembly, referring to "DOOR

REPLACEMENT".
Replacement of door components are as follows:

7. Place door assembly on a soft cloth with latches facing

up.

Note: As the engaging part of choke cover and door frame

are provided at 15 places, do not force any particular
part.

CHOKE COVER
8. Insert a putty knife (thickness of about 0.5mm) into the

gap 

A

 between the choke cover and door stopper and

between the choke cover and the door frame as shown
Figure C-3 to free engaging parts.

9. Pry the choke cover by inserting a putty knife in order

shown in Figure C-3.

10.Now choke cover is free from door panel and door frame.

DOOR FRAME ASSEMBLY
11.Remove two (2) screws holding the door panel to the

door frame assembly.

12.Release the door panel from the door frame assembly.
NOTE: It is easier to release the engaging parts of the upper

or lower door hinge pin side at first.

13.Now, door frame assembly is free.

LATCH SPRING, LATCH HEAD AND DOOR PANEL
14.Release the latch spring from the tab of the latch head

and tab of the door frame.

15.Release the latch head from the door frame.
16.Now, the latch spring and latch head are free.

Choke cover

Door stopper

Putty knife

Door frame

A