ZyXEL Access Point G1000 v2 91-005-124001B ユーザーズマニュアル

ZyXEL G-1000 v2 User’s Guide

100

Chapter 12 LAN Setup

Follow the instructions in the following table on how to configure the fields in this menu.

Use menu 3.5 to set up your G-1000 v2 as the wireless access point. To edit menu 3.5, enter 3 
from the main menu to display Menu 3 – LAN Setup. When menu 3 appears, press 5 and then 
press [ENTER] to display Menu 3.5 – Wireless LAN Setup as shown next. 

Figure 49   Menu 3.5 Wireless LAN Setup

Note: In the SMT, the ESSID is referred to as SSID. Both of them refer to the same ID 

for the G-1000 v2.

Table 41   Menu 3.2 TCP/IP Setup

IP Address 

Assignment

Press [SPACE BAR] and then [ENTER] to select Dynamic to have the G-1000 v2 

obtain an IP address from a DHCP server. You must know the IP address assigned 

to the G-1000 v2 (by the DHCP server) to access the G-1000 v2 again. 
Select Static to give the G-1000 v2 a fixed, unique IP address. Enter a subnet mask 

appropriate to your network and the gateway IP address if applicable.

IP Address

Enter the (LAN) IP address of your G-1000 v2 in dotted decimal notation

IP Subnet Mask

Your G-1000 v2 will automatically calculate the subnet mask based on the IP 

address that you assign. Unless you are implementing subnetting, use the subnet 

mask computed by the G-1000 v2.

Gateway IP 

Address

Type the IP address of the gateway. The gateway is an immediate neighbor of your 

G-1000 v2 that will forward the packet to the destination. On the LAN, the gateway 

must be a router on the same network segment as your G-1000 v2.

When you have completed this menu, press [

ENTER

] at the prompt “Press ENTER to Confirm…” to 

save your configuration, or press [

ESC

] at any time to cancel.

                         Menu 3.5 - Wireless LAN Setup

  ESSID= ZyXEL
  Hide ESSID= No
  Channel ID= CH06 2437MHz                  Edit MAC Address Filter= No
  RTS Threshold= 2432                       Edit Roaming Configuration= No
  Frag. Threshold= 2432                     Breathing LED= No
  WEP Encryption= 64-bit WEP
    Default Key= 1                          802.11 Mode= Mixed
    Key1= ********                          Output Power= 17 dBm
    Key2= ********                          Block Intra-BSS Traffic= No
    Key3= ********
    Key4= ********
    Authen. Method= Auto

                  Press ENTER to Confirm or ESC to Cancel: