ZyXEL Access Point G1000 v2 91-005-124001B ユーザーズマニュアル

ZyXEL G-1000 v2 User’s Guide

116

Chapter 15 System Information and Diagnosis

Note: The console port is internal and reserved for technician use only.

You can set up different port speeds for the console port through Menu 24.2.2 – System 
Maintenance – Console Port Speed. Your G-1000 v2 supports 9600 (default), 19200, 38400, 
57600 and 115200 bps console port speeds. Press [SPACE BAR] and then [ENTER] to select 
the desired speed in menu 24.2.2, as shown in the following figure.

After you changed the console port speed on your G-1000 v2, you must also make the same 
change to the console port speed parameter of your communication software.

To get to the log and trace information:

1 Enter 24 to display Menu 24 – System Maintenance. 

2 Enter 3 to display Menu 24.3 – Log and Trace.

3 From this menu you have one choice as shown in the next figure:

ZyNOS F/W Version

Refers to the ZyNOS (ZyXEL Network Operating System) system firmware 

version. ZyNOS is a registered trademark of ZyXEL Communications 

Corporation.

Country Code

Refers to the country code of the firmware. 

LAN

Ethernet Address

Refers to the Ethernet MAC (Media Access Control) of your G-1000 v2.

IP Address

This is the IP address of the G-1000 v2 in dotted decimal notation.

IP Mask

This shows the subnet mask of the G-1000 v2.

DHCP

This field shows the DHCP setting of the G-1000 v2. 

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC 

to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.

Table 49   Menu 24.2.1 System Maintenance: Information

Menu 24.2.2 – System Maintenance – Change Console Port Speed

Console Port Speed: 9600

Press ENTER to Confirm or ESC to Cancel: