ZyXEL Access Point G1000 v2 91-005-124001B ユーザーズマニュアル

ZyXEL G-1000 v2 User’s Guide

64

Chapter 5 IP and DNS Screens

To configure DNS settings, click Network > IP > Advanced. The screen appears as shown.

Figure 23   Network: Advanced

The following table describes the labels in this screen. 

IP Address

Enter the IP address of your G-1000 v2 in dotted decimal notation.

IP Subnet Mask Type the subnet mask.

Gateway IP 

Address 

Type the IP address of the gateway. The gateway is an immediate neighbor of your 

G-1000 v2 that will forward the packet to the destination. On the LAN, the gateway 

must be a router on the same segment as your G-1000 v2; over the WAN, the 

gateway must be the IP address of one of the remote nodes.

Apply

Click Apply to save your changes back to the G-1000 v2.

Reset

Click Reset to reload the previous configuration for this screen.

Table 23   Network: Internet Connection

Table 24   Network: Advanced

DNS Servers

First DNS 

Server
Second DNS 

Server
Third DNS 

Server

Select From ISP if your DHCP server dynamically assigns DNS server information 

(and the G-1000 v2's Ethernet IP address). The field to the right displays the (read-

only) DNS server IP address that the DHCP assigns.
Select User-Defined if you have the IP address of a DNS server. Enter the DNS 

server's IP address in the field to the right. If you chose User-Defined, but leave the 

IP address set to 0.0.0.0, User-Defined changes to None after you click Apply. If you 

set a second choice to User-Defined, and enter the same IP address, the second 

User-Defined changes to None after you click Apply.
Select None if you do not want to configure DNS servers. If you do not configure a 

DNS server, you must know the IP address of a machine in order to access it.
The default setting is None.