Omega CNiS32 ユーザーズマニュアル

Press  

d

11) Display flashes previous selection for “Alarm 2 Color Display”.

Press  

b

12) Scroll through the available selections: 

GRN, RED or AMBR.

Press  

d

13) Display shows 

STRD stored message momentarily and then

momentarily shows the software version number, followed by
RST Reset, and then proceeds to the Run Mode.

IN ORDER TO DISPLAY ONE COLOR, SET THE SAME DISPLAY
COLOR ON ALL THREE SUBMENUS ABOVE.

If user wants the Display to change color every time that both Alarm 1
and  Alarm 2 are triggered, the Alarm values should be set in such a way
that Alarm 1 value is always on the top of Alarm 2 value, otherwise value
of Alarm 1 will overwrite value of Alarm 2 and Display Color would not
change when Alarm 2 is triggered.

Example 1:
Output 1 & Output 2: SSR
Alarm Setup: Absolute, Above, Alarm 2 HI Value “ALR.H” = 200,

Alarm 1 HI Value “ALR.H” = 400

Color Display Setup: Normal Color “N.CLR” = Green, Alarm 1 Color
“1.CLR” = Amber, Alarm 2 Color “2.CLR” = Red

•--➤------------------------------•-----------------------------•------------------------------➤

0                                  AL2.H = 200                AL1.H = 400        

Example 2:
Output 1 & Output 2: Pulse
Alarms Setup: Absolute, Below, Alarm 2 Low Value “ALR.L” = 300, 
Alarm 1 Low Value  “ALR.L” = 100
Color Display Setup: "N.CLR" = Green, "1.CLR" = Amber, "2.CLR" = Red

• --------------•----------------------------------•------------------------------------------- --•

0             AL1.L = 100                      AL2.L = 300 

57

➤

➤