HP (Hewlett-Packard) 354903-001 ユーザーズマニュアル

− 

In RAID 1+0 configurations, any drives that are not mirrored to other 
removed or failed drives can be simultaneously replaced offline without 
data loss.  

To remove the component: 

  CAUTION:  To prevent improper cooling and thermal damage, 

do not operate the storage system unless all bays are populated with 
either a component or a blank.  

1.  Determine the status of the hard drive from the hot-plug hard drive LEDs 

("Hot-Plug SCSI Hard Drive LEDs" on page 

2.  Back up all data on the hard drive. 

3.  Remove the hard drive. 

 

To replace the hot-plug SCSI hard drive: 

1.  Slide the drive into the cage until it clicks, locking the drive into place. 

2.  Close the lever. 

3.  Be sure that the drive LEDs illuminate one at a time and then turn off 

together to indicate that the system has recognized the new drive. 

In fault-tolerant configurations, allow the replacement drive to be 
reconstructed automatically with data from the other drives. While 
reconstruction is in progress, the online LED flashes.