Makita EX2650LH ユーザーズマニュアル

P  11/ 14

Carefully assemble each part in right direction and order.

Connect 1R127 to the nipple of Carburetor as drawn in Fig. 53.

Give air pressure from 1R127 and check if the pressure gauge indicates

0.05Mpa for around 10 seconds, then, there is no problem with Carburetor.

(1) Assemble Cleaner plate assembly, Carburetor and Gasket to Insulator 

      with two M5x60 Hex socket head bolts.

(2) Connect black tube of Fuel tank to the nipple of Carburetor.

      Connect yellow tube of Fuel tank to the other nipple of Carburetor. 

      (Figs. 53 and 54)

      Connect Tube from Cylinder and Breather pipe to the Cleaner plate 

       assembly.

      Note: Make sure that fuel tubes do not touch on Cylinder cover.

(3) Set Air cleaner elements in place. The felt element is put on the bottom, 

      and the sponge element is on the front.

(4) Hook the tabs of Cleaner plate assembly with the holes of Cleaner cover 

      assembly.  (Fig. 55)

Check the continuity of two Lead wires’ ends 

routed from Control lever with Tester. (Fig. 56)

Stop switch is in order if it works as followings:

* Circuit tester shows no connectivity

   when Engine turns on.

* Circuit tester shows a connectivity

   when Engine turns off.

Assemble Tube complete (Black tube, Yellow tube and 

Grommet) to Fuel tank as drawn in Fig. 57.

Assemble Gasoline filter and Hose clamp to the black tube, 

then put them into Fuel tank. (Fig. 58)

ASSEMBLING

ASSEMBLING TO ENGINE

TEST OF AIRTIGHT STRUCTURE

Nipple of Carburetor to connect

black tube of Tank

(Nipple to connect

 yellow tube of Tank)

1R127

Hose clamp

Black tube

Gasoline filter

Tabs of 

Cleaner plate 

assembly

Yellow tube

Black tube

Grommet

Yellow

tube

Black 

tube

Tank