Makita EX2650LH ユーザーズマニュアル

DISASSEMBLING

ASSEMBLING

(1) Loosen two M6x30 Hex. socket head bolts and remove Protector with Protector 

      extension attached. (Fig. 7)

(2) While pulling the side walls of Protector cover toward outside, remove Protector cover 

      from Shaft pipe A complete. (Fig. 8)

(3) Remove two M5x14 Hex socket head bolts and Protector clamp. (Fig. 9)

(4) Loosen M5x25 Hex socket head bolt and remove Gear case assembly from Shaft pipe 

      A complete. (Fig. 9)

(5) Pull Shaft A from Gear case installation side and then remove Retaining ring S-7 from 

     Shaft A. (Fig. 10)

(6) Push the projection of Leaf spring complete deeply and remove it from the hole of 

      Shaft pipe A complete. Slip the projection along the inside of Shaft pipe A complete 

      toward the shaft end. (Fig. 11) Leaf spring complete is removed from Shaft pipe A 

      complete. 

Note: Pushing the projection hard causes the deformation of Leaf spring complete. Be careful of the handling. 

DISASSEMBLING

(1) Remove two M6x20 Hex. socket head bolts and Protector 

      from Clamp complete. (Fig. 12)

(2) Remove M5x10 Hex socket head bolt and Clamp complete 

      from Head case. (Fig. 12)

(3) Loosen M5x25 Hex socket head bolt and remove Head case 

      from Bent pipe assembly. (Fig. 12)

(4) Remove Bearing washer from Head case installation side of 

      Bent pipe assembly. (Fig. 13) 

      Remove Flexible shaft from Bent pipe assembly by pulling it

      off from shaft joint side.

(5) Remove two M5x14 Screws. Cutter is removed from Safety 

     cover as drawn in Fig. 14.

Assemble by reversing the disassembly procedure.

M6x30 Hex socket

head bolt (2pcs.)

Protector

Protector

extension

P  4/ 14

M5x14 Hex socket

head bolt

M5x14 Hex

socket head

bolt (2 pcs.)

Protector cover

Shaft pipe A complete

Shaft pipe A complete

Shaft pipe A complete viewed

from Gear case installation side

Retaining 

ring S-7

Shaft A

Projection of Leaf

spring complete

Spring portion of

Leaf spring complete

Protector

Bearing washer

Flexible shaft

Cutter

M5 Spring washer

(2 pcs.)

M5 Nut

(2 pcs.)

Safety cover

M5 Washer 

(2 pcs.)

M5x14 Screw (2 pcs.)

Bent pipe assembly viewed 

from Head case side

Head case complete

Protector

clamp

Gear case

assembly

M5x25 Hex 

socket head

bolt

Side wall

of Protector 

cover

Bent pipe assembly

Clamp complete

M6x20 Hex socket

head bolt (2 pcs.)

M5x10 Hex socket

head bolt

M5x25 Hex

socket head

bolt