Makita DPC7331HD ユーザーズマニュアル
8
Instructions for periodic maintenance
To ensure long life, prevent damage and ensure the full functioning of the safety features the following maintenance must be per-
formed regularly. Guarantee claims can be recognized only if this work is performed regularly and properly. Failure to perform the
prescribed maintenance work can lead to accidents!
Users of the Power Cut must not perform any maintenance work not described in this Instruction Manual. All such work must be
Users of the Power Cut must not perform any maintenance work not described in this Instruction Manual. All such work must be
carried out by a MAKITA service centre.
Page
General
Entire Power Cut
Clean exterior, check for damage. In case of damage,
have repaired by a qualified service centre immediately
Cutting disc
Inspect regularly for damage and wear.
7
Clutch
Have inspected at a service center.
Protection hood
Clean, Check position (impact plate)
16
Before each start
Cutting disc
Inspect for damage and make sure the cutting wheel is
7
right for the job
V-belt
Check V-belt tension
19
Protective hood
Adjust position
Combination switch,
Functional check
Safety locking button,
Functional check
Throttle lever
Functional check
16
Tank cap
Check for tightness and lekages
Every day
Air filter
Clean (if necessary more frequently); pre-filter (foam)
maintenance as described above under Cleaning /
changing the air filter
0-1
Idle speed
Check (cutting disc must not turn on idle)
18
Extreme dust
Clean filter insert (paper cartridge)
20-21
Every week
Starter housing
Clean to ensure proper air cooling
1
Starter cable
Check for damage
V-belt
Check V-belt tension, inspect for damage and wear
14, 19
Air filter insert
Clean, replace after 100 operating hours
20-21
Spark plug
Check and replace if necessary
Muffler
Check tightness of mounting, clean or replace
1 / 6
spark arrester screen if necessary
Every 3 months
Suction head
Replace
Fuel tank
Clean
Annually
Entire Power Cut
Check at an authorized service centre
Storage
Entire Power Cut
Clean exterior, check for damage. In case of damage,
have repaired by a qualified service centre immediately
Cutting disc
Remove and clean
1
Fuel tank
Empty and clean
Carburetor
Run empty