Porter-Cable PCB370SS ユーザーズマニュアル
17
OPERATION
Fig. R
REPLACING THE BULB (FIG. S)
1. Use only a 10 watt maximum bulb. Turn the light
1. Use only a 10 watt maximum bulb. Turn the light
switch off and unplug the saw.
2. Turn the old bulb counterclockwise then remove
it. Place a new bulb (1) into socket (2) and turn it
clockwise until it locks into position.
clockwise until it locks into position.
Fig. S
OVERLOAD BREAKER (Fig. R, T)
When the motor is overloaded during operation, the
overload breaker switch (4) will cause the motor to stop
automatically to prevent damage to the motor. Push in
the ON/OFF switch (2) to turn saw OFF, after that push
the ON/OFF switch (2) to ON to start the saw.
When the motor is overloaded during operation, the
overload breaker switch (4) will cause the motor to stop
automatically to prevent damage to the motor. Push in
the ON/OFF switch (2) to turn saw OFF, after that push
the ON/OFF switch (2) to ON to start the saw.
Fig. T
VARIABLE SPEED CONTROL AND ON/OFF SWITCH
CAUTION
!
● For your own safety, always push the switch
“OFF” when the scroll saw is not in use. Also,
in the case of power failure (all of your lights
go out) push the knob “OFF”. Remove the plug
from the power source outlet to avoid accidental
starting.
in the case of power failure (all of your lights
go out) push the knob “OFF”. Remove the plug
from the power source outlet to avoid accidental
starting.
● The variable speed control allows greater
versatility to cut a variety of materials such
as wood, plastics, non-ferrous metals, etc.
Depending on the hardness and thickness of
material, the speed should be reduced to allow
the blade teeth to remove cut material from the
kerf.
as wood, plastics, non-ferrous metals, etc.
Depending on the hardness and thickness of
material, the speed should be reduced to allow
the blade teeth to remove cut material from the
kerf.
VARIABLE SPEED CONTROL KNOB (FIG. R)
The variable speed control allows greater versatility to
cut a variety of materials such as wood, plastics, non-
ferrous metals, etc. Depending on the hardness and
thickness of material, the speed should be reduced to
allow the blade teeth to remove cut material from the
kerf.
1. Your saw is equipped with a variable speed control
The variable speed control allows greater versatility to
cut a variety of materials such as wood, plastics, non-
ferrous metals, etc. Depending on the hardness and
thickness of material, the speed should be reduced to
allow the blade teeth to remove cut material from the
kerf.
1. Your saw is equipped with a variable speed control
knob (1). The blade stroke rate may be adjusted by
simply rotating the variable speed control knob (1).
simply rotating the variable speed control knob (1).
2. Turn the control knob clockwise to increase up to
1,500 strokes per minute (SPM). Turn the control
knob counterclockwise to reduce, down to 500
strokes per minute (SPM).
knob counterclockwise to reduce, down to 500
strokes per minute (SPM).
ON/OFF SWITCH (FIG. R)
1. To turn power ON, press on/off rocker switch (2) to
1. To turn power ON, press on/off rocker switch (2) to
“ON” position.
2. To turn power OFF, press on/off rocker switch to
“OFF” position.
WORK LIGHT (FIG. R)
1. To turn work light on, press on/off rocker switch (3) to
1. To turn work light on, press on/off rocker switch (3) to
“ON” position.
2. To turn off work light, press on/off rocker switch to
“OFF” position.
O
N
3
2
1
1
2
4