Patton electronic 07MSN4980-90 ユーザーズマニュアル

2. Configuring the desired IP address

SmartNode 4980 & 4990 User Manual 

The factory default configuration for the Ethernet interface IP addresses and network masks are listed in 

Both Ethernet interfaces are activated upon power-up. LAN interface ETH 0/1 (LAN) provides a default 
DHCP server, the WAN interface uses DHCP client to automatically assign the IP address and network mask.

If these addresses match with those of your network, go to section 

 on page 32. Otherwise, refer to the following sections to change the addresses and network masks.

For configuring the IP address of the integrated WAN interface 
(G.SHDSL), please refer to Chapter 5,

To access the SmartNode, start the Telnet application. Type the default IP address for the SmartNode into the 
address field: 192.168.1.1. Accessing your SmartNode via a Telnet session displays the login screen. Type the 
factory default login: administrator and leave the password empty. Press the Enter key after the password 
prompt. 

 

login:administrator

 

password: <Enter>

 

192.168.1.1>

 

After you have successfully logged in you are in the operator execution mode, indicated by > as command line 
prompt. With the commands enable and configure you enter the configuration mode.

 

192.168.1.1>enable

 

192.168.1.1#configure

 

192.168.1.1(cfg)#

Select the context IP mode to configure an IP interface.

 

192.168.1.1(cfg)#context ip router

 

192.168.1.1(ctx-ip)[router]#

 

Table 9. Factory default IP address and network mask configuration

DHCP

DHCP

192.168.1.1

255.255.255.0

192.168.1.10–192.168.1.99 

 255.255.255.0