Multiquip FS2 ユーザーズマニュアル
PAGE 24 — MQ-WHITEMAN FS2 CONCRETE SAW — PARTS & OPERATION MANUAL — REV. #2 (11/08/01)
3.
Check V-belt tension (Figure 15) by using a tensionmeter
(6.0 - 9.0 lbs) against the inside belt at a mid point between
the two pulleys, or by deflecting the center belt at a mid point
3/8” (10mm) - 1/2” (13mm).
(6.0 - 9.0 lbs) against the inside belt at a mid point between
the two pulleys, or by deflecting the center belt at a mid point
3/8” (10mm) - 1/2” (13mm).
Figure 15. V-Belt Tension
4.
DO NOT over or under tension the V-belts. Severe damage
can occur to the saw and engine crank shaft if the belts are
over tensioned. A decrease of power to the blade and poor
performance will result if the belts are under tensioned (loose
on pulleys).
can occur to the saw and engine crank shaft if the belts are
over tensioned. A decrease of power to the blade and poor
performance will result if the belts are under tensioned (loose
on pulleys).
5.
If
the V-belts becomes worn or loose, replace them by using
V-belt part number 15082.
FS2 CONCRETE SAW — INSPECTION -GUARDS, COVERS AND V-BELTS