Southbend SB1020 ユーザーズマニュアル

For Machines Mfg. Since 8/09

Model SB1020

-43-

220V Switch (Part No. PSB1020204) ...................1

Phillips Screwdriver #2 ........................................1

Wrench 18mm .......................................................1

Wire Nut (sized for three 14 Ga. wires) ...............1

Electrical Tape .......................................As needed

Wire Stripper ..........................................As needed

1.  DISCONNECT BANDSAW FROM POWER!

2.  Open the motor junction box, then loosen the 

wire terminal screws indicated in Figure 51. 

Remove the wires connected to those termi-

nals.

Wiring diagrams are provided in this section 

showing the Model SB1020 wired for both 110V 

and 220V. Refer to these diagrams if needed 

when following this procedure. Additionally, 

you must purchase a 220V switch in order to 

complete the conversion.

6

1

4

5

2

3

6

1

4

5

2

3

GND

1

2

3

4

1

2

3

4

5.  Close the motor junction box.

6.  Remove the four hex bolts that secure the 

machine to the cabinet, then with the help 

of another person, remove the machine from 

the cabinet. Carefully place the machine on 

its side to gain access to the underside of the 

base.

7.  Remove the black plastic switch cover from 

behind the switch. Disconnect the two wires 

from the back of the switch, then remove the 

switch.

8.  Install the 220V switch into the machine 

base, then replace the two wires removed in 

Step 7 in the corresponding locations from 

which they were removed.

9.  Replace the switch cover, then with the help 

of another person, place the machine back 

onto the cabinet and secure it with the hex 

bolts removed in Step 6.

3.  Use a wire nut to connect wires #2, #3, and 

#5, then wrap them with electrical tape.

4.  Connect wires #1 and #6 to the upper right 

terminal and wire #4 to the lower right 

terminal shown in Figure 52. Tighten the 

terminal screws to secure the wires.

6

1

4

5

2

3

6

1

4

5

2

3

GND

1

2

3

4

1

2

3

4