Makita HRH01 ユーザーズマニュアル

When inserting Armature into Inner housing complete,

do not fail to pass Armature through Yoke unit in advance.

Note: Yoke unit is not directional when assembled

          with Armature. 

Without enough care, Ball bearing 6001DDW on the

drive-end of Armature may often be incompletely seated

in the bearing room of Inner housing complete.

Therefore, fit Ball bearing 6001DDW completely into

the bearing room in Inner housing complete while carefully

turning Armature by hand to engage the gear of Armature

shaft with Spiral bevel gear 26 in Inner housing complete. 

Then fix Ball bearing 6001DDW with Bearing retainer

and two M4x12 Hex socket head bolts.

Note: Be sure to apply adhesive (ThreeBond 1321B/

          1342 or Loctite 242) to the threads when reusing

          M4x12 Hex socket head bolts removed from

          the machine because they are threadlocking bolts.

Make sure that the five parts shown below are set in place 

before mounting Housing R to Housing L.

ASSEMBLING

M4x12 Hex socket 

head bolt (2 pcs.) 

with adhesive

Armature

Bearing retainer A

Compression

spring 10 (2 pcs.) 

Light circuit

Vibration isolator plate

Support plate

Pin 6 (2 pcs.)

P 12/22