Milwaukee 5303-20 ユーザーズマニュアル

page 5

reduce

the

risk

injury,

always unplug tool before attaching or remov-

ing accessories. Use only specifically recom-

mended accessories. Others may be

hazardous.

TOOL ASSEMBLY

WARNING!

Removing the Chuck (Fig. 1)

1. Hold the chuck firmly and pull back sleeve toward direction of arrow

(1).

2. Chuck pops out of the spindle, hold it firmly (2).

Inserting the Chuck
1. Push chuck into spindle turning until locked into position.
2. Remember to clean and lightly grease the spindle from time to time.

Inserting Drill Bit or Chisel (Fig. 2)
NOTE: Only use accessories with SDS-plus shank.

1. Align the symbol

with dimple on front of chuck.

2. Rotate bit slowly until it aligns with locking mechanism.
3. Push the bit in, turn it slightly until it can be pushed in completely and

you can feel the notch fit into place.

4. Turn the chuck collar so that the symbol

aligns with dimple on

front of the chuck. The tool should now be locked.

5. Check that the bit is locked properly it should be possible to move

it slightly.

6. To remove bits and chisels, turn chuck collar so that the symbol

aligns with dimple on the front of chuck. Remove bit.

Adjusting the Side Handle Position (Fig. 3)

Fig. 3

Side Handle

Clamping Screw

1. Loosen the clamping screw slightly.
2. Pull the side handle forward and turn it to the required angle.
3. Fit the side handle into the nonslip mounting until it adjusts into place

and retighten the clamping screw.

NOTE: The side handle can be locked in increments of 30 degrees.

Setting the Depth Gauge (Fig. 4)

Fig. 4

Drilling Depth

Fig. 2

Symbol

Dimple

1. Loosen the clamping screw.
2. Slide the depth gauge rod backward or forward until it is set

for the desired depth. NOTE: The drilling depth is the

distance between the tip of the bit and the tip of the depth gauge rod.

3. Tighten the clamping screw securely.

Fig. 1