Graco 258870 ユーザーズマニュアル

1.

Engage trigger lock and put control lever UP to release 
pressure in the sprayer. 

2.

Install filter to Spray Tip/Guard Assembly. Make sure 
filter is fully installed into sprayer. NOTE: Filter assem-
bly is reverse-threaded. Turn left (or counter-clock-
wise) to install. Turn right (or clockwise) to remove.

3.

Firmly screw Tip/Guard Assembly onto sprayer. 
Tighten retaining nut until completely engaged with 
sprayer. If Tip/Guard Assembly is not fully tightened, 
poor spray results and possible damage to the sprayer 
could occur.

1.

Attach the metal eyelet to the back of the sprayer. 

2.

Open the velcro end of the strap, then route it through 
the slot under the tip of the sprayer.

3.

Route velcro up through the metal triangle, then fold 
down and attach velcro to strap.

Thin stains, 

semi-transparent stains

Enamels, solid 

stains, thin latex

Heavy latex

311

315, 515

517

*For thin materials install Fine-Finish Optimizer, page 10.
NOTE: Spraying thicker materials with a 311 tip may cause the 
motor to overheat. Use the Reversible Tip Chart to determine 
the correct tip for your application. If motor does overheat, allow 
sprayer to cool for 20-30 minutes before operating. 

Make sure filter is completely screwed into the Tip/Guard 
Assembly to avoid splattering material or damage to the 
filter. 

ti14999a

ti14994a

ti14775a

ti14997a

The tip is a permanently attached to the guard. 
Removing the tip from the guard will result in damage 
to tip assembly.