Graco 258870 ユーザーズマニュアル

1.

Engage trigger lock and pull control lever UP to 
release pressure.

2.

Remove material cup and properly dispose cup liner 
or excess material. 

3.

Remove and clean sprayer intake tube and screen 
with water (or flushing fluid) and a brush every time 
you flush the sprayer. Reconnect intake tube.

4.

Clean cup if not using a liner, and fill with water or 
appropriate flushing fluid.

5.

Reconnect material cup and shake sprayer to move 
clean water around and clean all areas inside of 
cup and underside of sprayer.

6.

Disengage trigger lock and trigger sprayer for 
approximately 15 seconds. Engage trigger lock.

Failure to properly clean sprayer after each use will result 
in hardened materials, damage to the sprayer, and the 
warranty will no longer be valid.

Use only water-based or oil-based (mineral 
spirit-type) materials with flash point greater than 
100° F (38° C). Do not use materials which state 
“FLAMMABLE” on the packaging. For more 
information about your material, request MSDS 
from distributor or retailer. 

Use oil-based material outdoors or in a well-ventilated 
indoor area with a flow of fresh air.

Keep spray area well-ventilated. Keep a good supply 
of fresh air moving through the area.

Protect the internal parts of this sprayer from water. 
Do not submerge the sprayer in cleaning fluid. Openings 
in shroud allow cooling of mechanical parts and electron-
ics inside. If water gets into these openings, the sprayer 
could malfunction or become permanently damaged.

ti14994a

ti14999a

ti15002a

ti15001a

ti15441a

ti14994a