Allstar Products Group Paint Sprayer プリント

Form 1048   

 

 

Page 1 of 1 

Rev. 020708

Piston Rod Guide

TO REMOVE PISTON:

1. 

Remove nuts from piston rod bolts.

2. 

Place small adapters into prong ends and onto rod bolt ends.

3. 

Tap base of tool with palm of hand or hammer to break loose rod cap union.

4. 

Remove bottom rod cap and small adapters.

5. 

Place prong ends of tool onto piston rod bolts and push on base to remove piston rod   

 

ends through cylinder bore.

Contents List:
1 - Rod Guide
2 Sets - Quick Change Adapters

TO INSTALL PISTON:

1. 

Spread prongs of tool over crankshaft and push up through cylinder bore and onto  

 

 

piston rod bolts.

2. 

Apply piston ring compressor and start piston into cylinder bore.

3. 

Tool may be removed when piston rod properly seals onto crankshaft.

 

This guide tool provides user with a "GO" or "NO GO" feature. If rod angle isn't correct    

 

during removal and installation of piston, the tool will not allow you to continue with   

 

out making adjustments to correct crankshaft angle by turning crankshaft. This helps    

 

prevent damage to crankshaft and cylinder walls caused by misalignment.

A safe, easy-to-use tool designed to assist in the re-

moval and installation of pistons and rod assemblies. 

Rod guide has two sets of quick change adapters 

that snap in and out of prong ends.

Constructed of durable high quality plastic to pro-

tect from metal to metal contact. Prevents damage 

to crankshafts and piston cylinder walls by protect-

ing exposed piston rod bolts, and at the same time, 

safely guides piston rods during removal and instal-

lation.

Related Component (Sold Separately):
ALL96481 

4.5" Rod Guide Tool Extensions, 1-Pair