Ingersoll-Rand 635040 プリント
OPERATOR’S MANUAL
635040
RELEASED:
11-4-81
REVISED:
6-30-00
(REV. B)
ARO STOP
R
OPERATION, INSTALLATION & MAINTENANCE
635040
PUMP SAVER CONTROL VALVE - 1/4” PIPE SIZE
READ THIS MANUAL CAREFULLY BEFORE INSTALLING,
OPERATING OR SERVICING THIS EQUIPMENT.
It is the responsibility of the employer to place this information in the hands of the operator. Keep for future reference.
GENERAL DESCRIPTION
This device is to terminate operation of a 2" to 3Ć1/4" reciprocating type
air motor in the event of a ruptured outlet hose or the pump runs out of
media. For compressed air use only.
Operating Pressure Range
20 Ć 175 p.s.i. (1.4 Ć 12 bar)
. . .
Temperature Range
0_ to 180_F ( Ć18_ to 82_C)
. . . . . . . . .
OPERATION
The AROĆSTOP control valve senses an increased volume of air to the
pump, beyond the preadjusted setting, and shuts off the air supply to
the pump. The runaway" condition may be caused by any of the followĆ
ing: 1.) depleted pumping material, 2.) a ruptured line on the outlet of
the pump, 3.) excessive cavitation in the material supply.
INSTALLATION
The AROĆSTOP valve should be installed in a filtered and regulated air
line. The Filter & Regulator should be no smaller than an Aro Module /
Air 2000 series. Upstream plumbing from the AROĆSTOP valve should
be 1/4" minimum. The Aro 1/4 coupler & connector furnished with
this model is to be installed on the inlet of the AROĆSTOP valve as
shown. Connect the 1/4 female end of the hose to the outlet of the
AROĆSTOP valve. Installing these items as illustrated is recommenĆ
ded. Use one AROĆSTOP valve for each pump. See installation photo
below.
To pump air inlet. a
a From FĆRĆL.
E
2000
D
PRINTED IN U.S.A.
&
(419) 636-4242
D
FAX (419) 633-1674
INGERSOLL-RAND COMPANY
P.O. BOX 151
D
ONE ARO CENTER
D
BRYAN, OHIO 43506Ć0151
AROĆSTOPR is a registered trademark of The Aro Corporation.