Woodstock W1747 ユーザーズマニュアル

-16-

W1747 20" Planer

Test Run

Complete this process once you have familiarized yourself

with all instructions in this manual

. The purpose of the

test run is to make sure the motor is working properly

before proceeding.

To perform a test run, do these steps:

1. Read the entire manual, and make sure oil is in the

gearbox.

2. Make sure all tools and foreign objects have been

removed from the machine.

3. Put on safety glasses, and secure loose clothes or

long hair.

4. Press the green button to turn the machine ON. The

planer should run smoothly with little or no vibra-

tion.

— If you suspect any problems, immediately turn

the planer

OFF by pushing the red STOP button.

Refer to

Page 40 to troubleshoot/fix any problems

before starting the planer again.

— If the source of an unusual noise or vibration is not

readily apparent, contact our technical support

for help at (360) 734-3482 or contact us online at

tech-support@shopfox.biz.

Loose hair and clothing could get

caught in machinery and cause serious

personal injury. Keep loose clothing

rolled up and long hair tied up and

away from machinery.

Tighten V-Belts

The final step in the set up process must be done after

approximately 16 hours of operation. During this first 16

hours, the V-belts will stretch and seat into the pulley

grooves. After this 16 hours, the V-belts must be ten-

sioned or your belts will slip and burn out. Refer to

Page

24 when you are ready to perform this important adjust-

ment.

Note: Pulleys and belts run very hot. This is a normal

condition. Allow them to cool before making adjustments.

Note: A collection of black belt dust at the bottom of the

belt housing is a normal during the life of the machine

and does not indicate premature belt failure is in prog-

ress.

For your convenience, the adjustments

listed below have been performed at the

factory and no further setup is required to

operate your machine.

However, because of the many variables

involved with shipping, some of these

adjustments may need to be repeated

to ensure optimum cutting results. Keep

this in mind as you start to use your new

planer.

Step-by-step instructions for these adjust-

ments can be found in

the SERVICE sec-

tion

1. Table Parallelism (Page 29).

2. Chain Tension (Page 28).

3. Spring Tension (Page 34).

4. Rollers, Chip Breakers and Pressure

Bar Heights (

Page 31).

5. Chip Deflector Positioning (Page 35).

Recommended

Adjustments