Graco Inc. 309322D ユーザーズマニュアル

Misuse can cause death or serious injury.

•

Do not operate the extension tube or roller frame or use 
parts not designed for this equipment.

•

Do not use 1,1,1-trichloroethane, methylene chloride, 
other halogenated hydrocarbon solvents or fluids contain-
ing such solvents in pressurized aluminum equipment. 
Such use can cause serious chemical reaction and equip-
ment rupture, and result in death, serious injury, and prop-
erty damage.

Improper grounding, flammable fumes, such as sol-
vent and paint fumes, in work area can ignite or 

explode. To help prevent fire and explosion:

•

Provide fresh air ventilation to avoid the buildup of flam-
mable fumes from flushing fluids or the coating being 
applied.

•

Keep the application area free of debris, including solvent, 
rags, and gasoline.

High-pressure fluid from hose leaks, or ruptured com-
ponents will pierce skin. This may look like just a cut, 

but it is a serious injury that can result in amputation. Get 
immediate surgical treatment.

•

Keep your hands and body away from the roller frame 
when flushing. High pressure fluid emitted from the holes 
in the frame could cause an injection injury.

•

Always relieve pressure before you check or repair leaks 
and when you turn off the pump or stop painting.

•

Never use components rated less than system Maximum 
Working Pressure.

Failure to observe the electrical hazards described 
below could result in serious injury, including burns or 

electrocution. To help prevent harmful electrical shock:

•

Avoid contact with power lines.

•

Follow all grounding instructions in your separate pump 
and gun instruction manual, and comply with all local, 
state, and national fire, electrical, and safety regulations.

•

Use only Graco paint hoses.

1.

Follow Pressure Relief Procedure on page 1.

2.

Prime pump.

3.

Install roller frame.

This is the procedure for flushing the pressure roller. The 
pump and gun you are using may have additional flushing 
steps, such as cleaning filters and screens. See the pump and 
gun flushing instructions.

NOTE: Leave the pressure roller attached to the gun for this 
procedure.

See Pressure Relief Procedure 

on page 1.

1.

Relieve the pressure.

2.

Remove roller cover and diffuser (3) from roller frame (1) 
as follows (see Parts Drawing).

a.

Use your thumb to press down on clip (5) to release 
end caps (2 and 4), diffuser (3), and roller cover into a 
pail.

b.

Remove roller cover from diffuser (3).

c.

Pull end caps (2 and 4) off diffuser (3).

3.

Clean roller cover, caps (2 and 4) and diffuser (3) with 
water or a compatible fluid for oil-based materials. 

4.

Place roller frame (1) in paint pail. Be sure the holes in 
roller frame (1) are facing inside the paint pail. 

5.

Prim pump with water or flushing fluid for oil-based materi-
als. Use the lowest pump priming pressure setting.

6.

Turn prime/spray valve to SPRAY. 
NOTE: Perform step 7 at the lowest pressure possible.

7.

Trigger gun until flushing fluid begins to dilute the paint.

8.

Place roller frame (1) in another bucket and continue 
flushing until fluid coming out of the roller frame (1) is 
clear. 

9.

Shut off the pump. Turn prime/spray valve to PRIME.

Refer to your sprayer and spray gun manuals for appropriate 
warnings and instructions for safe operation of this roller 
frame.

Gasket (12) must be in place before installing frame (1). If 
gasket is not in place, there is a potential injection hazard 
which could result in serious injury.