Hitachi NT 65MA4 (S) ユーザーズマニュアル

12

(7) If no abnormal operation is observed, you 

may load nails in the Nailer.

  Drive nails into the workpiece that is 

the same type to be used in the actual 

application.
□  The nailer must operate properly.

● Do not exceed 120 psi (8.3 bar 8.5 

Adjust the air pressure at recommended 

operating pressure 70 – 120 psi (4.9 – 8.3 

bar  5 – 8.5 kgf/cm

2

) according to the length 

of nails and the hardness of workpiece.

The correct air pressure is the lowest 

pressure which will do the job. Using the 

Nailer at a higher than required air pressure 

unnecessarily over stresses the Nailer.
Loading nails

● When loading nails into the nailer, 

(1) Insert nail strip into rear of magazine.

Magazine

(2) Slide the nail strip forward in the magazine.

 

The nail strip should pass the nail stopper.

Nail Stopper

(3) Pull the nail feeder (B) back to engage the 

nail feeder (A) to the nail strip.

Nail Feeder (B)

Nail Feeder (A)

 

○ Use nail strip at least 5 nails remaining.

The Nailer is now ready to operate.

Removing the nails:
1

 Depress the nail feeder (A) slightly and 

slowly slide the nail feeder (B) forward.

2

  Remove the nails from the Nailer.

Nail Feeder (A)

1

2

000Book_NT65MA4(S)_US.indb   12

000Book_NT65MA4(S)_US.indb   12

2010/11/24   9:04:29

2010/11/24   9:04:29