Husqvarna SG13B ユーザーズマニュアル

OPERATION

HUSQVARNA

-31

Before moving the machine forwards, you should 

11. 

ensure that the cutting wheel is above the ground 

and located on either side of the stump. Move the 

machine forward by releasing the brake, pushing it 

forward, activating the brake again and repeating 

Steps 9 and 10.
Repeat Steps 9 through 11 until the upper portion 

12. 

of the stump has been removed. DO NOT cut 

deeper than ground level at this stage.
Set the throttle to SLOW/(START) DISENGAGE 

13. 

and wait until the cutting wheel stops rotating.
Release the brake and pull the machine away from 

14. 

the stump.
It may be necessary to clear wood chips from the 

15. 

area around the stump.
If you want to grind below the ground level, it may 

16. 

become necessary to adjust the handle position to 

achieve a better hand and arm work position. Pull 

the handle control lever and adjust the handle to 

the desired position.
Repeat Steps 6 through 10 until you reach the 

17. 

desired depth.
Shut off the machine when you are done.

18. 

Be very careful when operating the stump grinder 

on hills because the machine can slip or move 

unexpectedly.
NEVER use the machine on grades of 10° or steeper.

The Husqvarna stump grinder can be transported in a 

truck, trailer, van or a large SUV (Sport Utility Vehicle). 

The stump grinder is equipped with four lifting handles 

(two on each side) so that two people can lift the 

machine if necessary.
DO NOT attempt to lift the machine alone. Use safe 

lifting techniques and DO NOT exceed your physical 

limitations.
Secure the machine with tensioning belts, chains or 

other approved materials.