Echo SRM-210SB ユーザーズマニュアル

Level 1.

Tools Required: 8 mm Open End Wrench, Screwdriver, Clean Rag

Parts Required: ECHO

®

 LUBE

TM

 8 oz. (P/N 91014) or Lithium Base

Grease.

1.

Clean all loose debris from gear box.

2.

Remove plug (A) and check level of grease.

3.

Add grease if necessary, DO NOT over fill.

IMPORTANT
Lower and upper drive shaft must  be lubricated with high tempera-
ture automotive grease every 25 hours of operation, otherwise
drive shaft assembly overheating and failure can result.

1. Loosen two (2) screws (B) and remove center locating screw (C).

Pull gear box and shield from drive shaft housing.

2. Pull flexible cable from the drive shaft housing, wipe clean and

re-coat with a thin coating [15 ml (1/2 oz.)] of  ECHO

 LUBE

TM

.

3. Slide the flexible cable back in the drive housing. DO NOT get

dirt on the flex cable.

4. Install the gear housing and shield assembly.

1. Remove coupler (D) from upper drive shaft assembly by loosening

clamping knob (E) and pulling locator pin (F) out, and turning 1/4
turn counter clockwise to lockout position.

2. Remove upper flex drive cable, wipe clean and apply a thin coating

15 ml (1/2 oz.) of  ECHO

 LUBE

TM

.

3. Install flex drive cable. Make sure that the flex cable engages into the

clutch mount and also into the coupler mount.

4. Slide coupler on upper drive shaft until fully seated. Rotate locator

pin 1/4 turn clockwise to engage lower shaft hole. Insure locator pin
is fully engaged by twisting lower drive shaft.

5. Secure lower shaft assembly to coupler by tightening clamping knob

(E).