Zenoah LRTZ2401 ユーザーズマニュアル

■ STARTING ENGINE

1. Rest the unit on a flat, firm place. Keep the cutting

head off the ground and clear of surrounding objects
as it will start rotating upon starting of the engine.

2. Push the primer pump several times until overflown

fuel flows out in the clear tube. (OP1)

3. Move the choke lever to the closed position. (OP2)
4. Set the ignition switch to the “Start” position. While

pulling the throttle lever, push the throttle set button,
and release the throttle, then the throttle lever is in to
the “Start position”. (OP3)

5. While holding the unit firmly, pull out the starter rope

quickly until engine fires. (OP4)

• Avoid pulling the rope to its end or returning it by

releasing the knob. Such actions can cause starter
failures.

6. Move the choke lever downward to open the choke.

And restart engine. (OP2)

7. Allow the engine to warm up for several minutes

before starting operation.

1. When restarting the engine immediately after

stopping it, leave the choke open.

2. Overchoking can make the engine hard to start due

to excess fuel. When the engine failed to start after
several attempts, open the choke and repeat pulling
the rope, or remove the spark plug and dry it.