Zenoah LRTZ2401 ユーザーズマニュアル

ページ / 56
30
8. Operation
English
■ STOPPING ENGINE (OP3)
1. Release the throttle lever and run the engine for a
half minute.
2. Shift the ignition switch to the STOP position.
• Except for an emergency, avoid stopping the engine
while pulling the throttle lever.
■ ADJUSTING THROTTLE CABLE
• The normal play is 1 or 2mm when measured at the
carburetor side end. Readjust with the cable adjuster
as required. (OP5)
(1) cable adjuster
■ ADJUSTING IDLING SPEED (OP6)
1. When the engine tends stop frequently at idling
mode, turn the adjusting screw clockwise.
2. When the cutting head keeps rotating after releasing
the trigger, turn the adjusting screw counter-
clockwise.
(1) idle adjusting screw
• Warm up the engine before adjusting the idling
speed. 
• This product is equipped with extremely sharp
blades, and when used improperly these blades
can be extremely dangerous, and improper
handling can cause accidents which may in turn
lead to serious injury or death. For this reason,
you should always be careful to follow the
following instructions when using your trimmer.
• Never hold the trimmer in a way in which the
blades are pointed towards someone else.
• Never allow the blades to come into proximity with
your body while the engine of the trimmer is in
operation.
• Always be sure to turn off the engine before
WARNING
NOTE
IMPORTANT
(1)
OP6
.04 in
(1~2mm)
(1)
OP5