Zenoah HTZ2401L-CA ユーザーズマニュアル

ページ / 54
24
7. Operation
English
■ STARTING ENGINE
The cutting head will start rotating upon the engine
starts.
1. Rest the unit on a flat, firm place. Keep the cutting
head off the ground and clear of surrounding objects
as it will start rotating upon starting of the engine.
2. Push the primer pump several times until overflown
fuel flows out in the clear tube. (OP1)
3. Move the choke lever to the closed position. (OP2)
4. Set the ignition switch to the “START” position.
(OP3)
(1) primer pump
(2) choke lever
(3) close  
(4) open  
(5) ignition switch 
(6) throttle lever
5. Holding the hedge-trimmer down, pull the starting
rope slowly until you meet resistance (OP4). Then
operatel hard several times, and when the engine
starts, wait for about 10 seconds and then pull the
throttle lever (OP3(6)), the choke lever (OP2(2)) will
return automatically to the original “OPEN” position. 
Use the semi-acceleration device only in the phase
of starting the engine.
• Avoid pulling the rope to its end or returning it by
releasing the knob. Such actions can cause starter
failures.
1. When restarting the engine immediately after
stopping it, leave the choke open.
2. Overchoking can make the engine hard to start due
to excess fuel. When the engine failed to start after
several attempts, open the choke and repeat pulling
the rope, or remove the spark plug and dry it.
NOTE
IMPORTANT
WARNING
WARNING
[HTZ2401]
[HTZ2401-CA]
[CHTZ2401]
[CHTZ2401-CA]
OP4
(1)
OP1
(2)
(4)
(3)
OP2
(5)
(6)
OP3