Zenoah HTZ7500 ユーザーズマニュアル

■ STARTING THE ENGINE

1. Release the throttle lever and

make sure it is fully back. (F1)

2. Set the engine switch to the “I

(RUN)” position. (F1)

3. Push the primer pump until

overflown fuel flows out in the
clear tube. (F2)

4. Move the choke lever to the

closed position. (F3)

5. Place the unit on a flat, firm place.

Keep the cutting head clear of
everything around it.

6. While holding the unit firmly, pull

out the starter rope quickly. (F4)

•

Avoid pulling the rope to its end or
returning it by releasing the knob.
Such actions can cause starter
failures.

7. Move the choke lever downward

to open the choke. and restart
engine. (F3)

8. Allow the engine to warm up for a

several minutes before starting
opertion.

1. When restarting the engine

immediately after stopping it,
leave the choke open. (F3)

2. Overchoking can make the engine

hard to start due to excess fuel.
When the engine failed to start
after several attempts, open the
choke and repeat pulling the rope,
or remove the spark plug and dry
it.

■ STOPPING THE ENGINE (F1)
1. Release the throttle lever.
2. Move the engine switch to the

“O(STOP)”position.

If the engine doesn’t stop after
stopping the switch, close the choke
so that engine will stop after a little.