Makita EM4340L ユーザーズマニュアル

For EM4341

– Fit the handle edge to the handle holder groove, and provisionally fix the

upper side (3) of the handle holder by four bolts M5 x 25 (4).

– Adjust the handle to an angle easy to manipulate, and tighten the bolt (4)

uniformly on the right and left sides.

Note: Handle mounting position.

– Pass the control cable (6) through the rear grip (7) and insert tube (8) in the

control cable (6).

– Fix the control cable to the handle and shaft by two clamps.

Note: If the control cable is not tight, it may be caught by a twig, leading to an

accident.

Lay out the control cable as indicated in the figure.

Note: If the control cable is not tight, it may be caught by a twig, leading to an

accident.

㩷

(4)

(3)

to engine

㩷

(6)

(8)

(7)