Makita BUR141 ユーザーズマニュアル

(2) After removing Motor housing R, Remove DC motor and Gear shaft complete as drawn in Fig. 3.

(3) Disassemble Gear shaft complete as drawn in Fig. 4.

DISASSEMBLING

3. Remove five 4x18 Tapping screws and 

    Motor housing R from Motor housing L.

4. Remove Gear shaft complete together with DC motor.

    And separate DC motor section from Gear shaft complete.

    Note: Be careful not to lose Rubber pin 4.

5. Remove M4x8 Pan head screw. And then, 

    install M4 Hex socket head bolt in preparation

    of the next step.  

6. Receive Spool holder with 1R022 and press M4 Hex

    socket head bolt with 1R236.   Spool holder is removed.

4x18 Tapping screw (5 pcs.)

Motor housing R

Motor housing L

DC motor

Rubber pin  4

(2 pcs.)

Gear shaft complete

Spool holder

Spool holder

Receive the bottom of 

Spool holder with 1R022.

1R236

1R022

Arbor press table

Arbor press

1R 217

M4 Hex socket 

head bolt

M4 Hex socket 

head bolt

Spur gear 48

Spur gear 48

Gear shaft

Ball bearing 696ZZ

Retaining ring S-8

Ball bearing 608ZZ

7. Holding Spur gear 48 with 1R217, 

    press M4 Hex. socket head bolt on 

   Gear shaft.  Spur gear 48 is removed.

8. Remove Ball bearing 696ZZ, Retaining 

    ring S-8, Ball bearing 608ZZ and M4 Hex.

    socket head screw from Gear shaft.

M4x8 Pan

head screw

Gear shaft

P  4/ 12

M4 Hex. socket

head screw