Oregon HT255 ユーザーズマニュアル

ページ / 420
20
OPERATING THE HEDGE TRIMMER
OREGON® CORDLESS TOOL SYSTEM 
HEDGE TRIMMER MODEL HT255
AD 0213 - F/N 558936
CUTTING HORIZONTALLY
When cutting the top of the hedge, start 
with the nearest edge  Hold the hedge 
trimmer with the cutting blades angled 
5–10° toward the direction of the cut  
Move down the line of the hedge, 
sweeping the hedge trimmer slowly left 
and right in a wide arc (Fig  18)  
If the hedge top is too wide to cut in one 
sweep of the hedge trimmer, do not lean 
over the hedge to trim the remainder  
Instead, make one pass down one side of 
the hedge, and then cut the remainder 
from the other side of the hedge 
CORRECTING BLADE BIND
 CAUTION: ALWAYS REMOVE 
THE BATTERY BEFORE CLEARING 
CUTTING BLADES TO AVOID 
ACCIDENTAL ACTIVATION OF THE 
CUTTING BLADES.
 CAUTION: CUTTING BLADES ARE 
SHARP. ALWAYS WEAR GLOVES 
WHEN CLEARING MATERIAL FROM 
THE CUTTING BLADES.
Sometimes when cutting flexible, “green” 
branches, clippings can become lodged 
between the moving parts of the cutting 
blades and the stationary part  When 
this happens, the cutting blades may 
suddenly cease to move  This can also 
happen if the cutting blades contact 
material too strong to cut through, such 
as a chain-link fence  This condition is 
called blade bind  
Follow these guidelines to safely and 
effectively clear the material 
• Wear gloves  
• Remove the battery pack from the 
hedge trimmer  See “Removing the 
battery pack”  
• Clear the material that is preventing the 
cutting blades from moving 
FIG. 18