Zenoah eHT600D ユーザーズマニュアル

English

5. OPERATION

■ STARTING THE ENGINE

Keep the blades clear of
everything around It as they will
start moving upon the engine
starts.

1. [eHT750S] Make sure that the

throttle lever is at idling position.
[eHT600D] Release the throttle
lever and make sure it is fully
back. (F1)

2. [eHT600D] Set the engine switch

to the “I (RUN)” position. (F1)

3. Push the primer pump until

overflown fuel flows out in the
clear tube. (F2)

4. Move the choke lever to the

closed position. (F3)

(1) Throttle lever

(7) Stop

(2) Full throttle

(8) Primer pump

(3) Idling (start position) (9) Clear tube
(4) Stop switch

(10) Choke lever

(5) Engine switch

(11) Open

(6) Run

(12) Close

5. Place the unit on a flat, firm place.

Keep the cutting head clear of
everything around it.

6. While holding the unit firmly, pull

out the starter rope quickly. (F4)

7. After the engine has started, allow

the engine to warm up. Pull the
throttle lever.

■ STOPPING THE ENGINE (F1)
[eHT750S]
1. Please return the throttle lever

completely.

2. Press the stop switch until the

engine comes to a complete stop.

[eHT600D]
1. Release the throttle lever.
2. Move the engine switch to the

“O(STOP)”position.

If the engine doesn’t stop after
stopping the switch, close the choke
so that engine will stop after a little.

NOTE

WARNING