Zenoah HT2200 ユーザーズマニュアル

■ HT2200
1. Join the engine unit to the clutch housing of the

cutter unit, with the fuel tank on the blade side. 

2. Align the mounting holes and tighten the engine

securely with the 3 screws. 

3. Remove the right handle mounting screw, nut, and

washer casually attached on the blade beam. 

4. Set the right handle on the beam making the grip

come to the opposite side of the cutting teeth, and
attach with the hardware removed before. When
fastening the nut, hold the screw to keep the blade
washer loose. 

• To assure designed cutting performance, always

keep a half spare turn for the blade screws. Over
tightening will cause blade seizure and premature
wear of the clutch system. Too loose screws will
make the gap between the blades large, and result
in poor cutting performance. 

5. Install the left handle to the bracket attached to the

clutch housing. Use the hardware as shown below.
(SE3)

6. Cover the throttle cable with corrugate tube. Connect

the throttle cable and the switch wire. Hold the wires
at the lower part of the handle using the tie band.
(SE4)

7. Check the cable play and, if necessary, adjust

between .04” and .08” by bending throttle wire
receiver of the bracket with needle nose pliers.