Zenoah HT2300A ユーザーズマニュアル

❲

❳

■

1. When first starting up after putting fuel into

the machine, push the priming pump until
fuel runs out in the clear tube. Then close
the choke. Choking may not be necessary
when re-starting right after stopping the
engine. 

2. Pull the throttle lever and push the lock

button to set the lever in the START
position. 

3. [CHT2300B/CHT2300L only] 

Slide the ignition switch to the engine side
to set it in the ON position. 

4. Rest the unit on a flat firm place. While

holding the unit with your left hand on the
starter housing, pull the starter knob
quickly. 

• Avoid pulling the rope to its end or returning

it by releasing the knob. Such actions can
cause starter failures. 

5. When the engine has started, gradually

open the choke. 

6. A l l o w the engine to warm up for a half

minute before starting operation. 

• If the engine won't start after several

attempts, open the choke and repeat
pulling the rope or remove the spark plug
and dry it. 

■

1. Release the throttle lever and run the

engine at idling speed for a half minute. 

2. Stop the engine by the stop switch. 

[HT2300A/HT2300L] Press on the stop
button until the engine stops completely. 

[CHT2300B/CHT2300L] Shift the ignition
switch to the STOP position.

• Except for an emergency, avoid stopping

the engine while running it at high speed.