Zenoah HT2300A ユーザーズマニュアル

■

1. Join the engine unit to the clutch housing

of the cutter unit, with the fuel tank on the
blade side. 

2. Align the mounting holes and tighten the

engine securely with the 3 screws. 

3. Remove the right handle mounting screw,

nut, and washer casually attached on the
blade beam. 

4. Set the right handle on the beam making

the grip come to the opposite side of the
cutting teeth, and attach with the hardware
removed before. When fastening the nut,
hold the screw to keep the blade washer
loose. 

• To assure designed cutting performance,

always keep a half spare turn for the blade
screws. It will cause blade seizure and
premature wear of the clutch system if they
are too tight. Too loose screws will make
the gap between the blades large, and
result in poor cutting performance. 

5. Install the left handle to the bracket

attached to the clutch housing. Use the
hardware as shown below. 

6. Attach the throttle lever and the engine

stop switch to the left handle, and connect
the throttle cable and the switch wire. Put
the rubber cap onto the switch button.
Hold the wires at the lower part of the
handle using the tie band. 

7. Check the cable play and, if necessary,

adjust between .04" and .08" (1~2mm) by
bending throttle wire receiver of the
bracket with a nipper. 

❲

❳