Zenoah HT2301 ユーザーズマニュアル

❲

❳

■

1. Rest the unit on a flat, firm place. Keep the

cutting head off the ground and clear of
surrounding objects as it will start rotating upon
starting of the engine.

2. Push the primer pump several times until

overflown fuel flows out in the clear tube. 

3. Move the choke lever to the closed position.

(OP1)

4. Set the ignition switch to the “START” position.

(OP2)

5. Holding the hedge-trimmer down, pull the

starting rope slowly until you meet resistance
(OP3). Then operatel hard several times, and
when the engine starts, wait for about 10
seconds and then pull the throttle lever (OP2(3)),
the choke lever (OP1(1)) will return automatically
to the original “OPEN” position. 

• Avoid pulling the rope to its end or returning it by

releasing the knob. Such actions can cause
starter failures.